Bennett Trim Tabs relay module

[intrepid2dev]

“Hi Joe,

just over 6 months ago I replaced the original Bennett tab control switch with the new EIC kit. I now find the connections on the relay module have corroded and this and the blue wire will have to be replaced. My installer mounted the module in the bilge area (of my 30 ft. open) as the wires from the pump to the module limited where it is placed. I am wondering where does Intrepid place the relay module on new installations and if longer wiring is needed for the placement if not in the bilge area? I am concerned about putting a new module in the same location and having to replace it in another couple of months!!! Your advise will be appreciated.

Thanks for your time,

Brian”

[Author]

Posts